Section 4 - Typical Installation - Ingersoll Rand System Automation X4I Manual De Configuración Rápida

VOLTAGE'. Do not switch on electrical power or
attempt to start the X4I if such a warning label is
attached.
•
Make sure that all instructions concerning
operation and maintenance are strictly followed
and that the complete unit, with all accessories
and safety devices, is kept in good working
order.
•
The accuracy of sensor devices must be checked
on a regular basis. They must be calibrated when
Refer to the X4I Operator's Manual and the X4I Interconnect and Application Guide for installation details.
New Picture above
All manuals and user guides at all-guides.com
SECTION 4 — TYPICAL INSTALLATION
acceptable tolerances are exceeded. Always
ensure any pressure within the compressed air
system is safely vented to atmosphere before
attempting to remove or install a sensor device.
•
The X4I must only be cleaned with a damp cloth,
using mild detergents if necessary. Avoid the use
of any substances containing corrosive acids or
alkalis.
•
Do not paint the control faceplate or obscure any
indicators, controls, instructions or warnings.
4