Cleaning And Maintenance - MSW Motor Technics MSW-PCSM-100-1 Manual De Instrucciones

E01
E02
E03
E04

3.4. Cleaning and maintenance

a) Before cleaning and when the appliance is not in use, unplug it from the mains
and isolate the compressed air supply.
b) Store the appliance in a dry and cool place, protected from moisture and direct
sunlight.
c) Do not spray the appliance with a stream of water and do not immerse it in
water.
d) Regularly inspect the appliance for technical defects and damage.
e) Use a soft cloth for cleaning.
f) Do not clean with any sharp and/or metal implements (e.g. a wire brush or a
metal scraper) as these may damage the surface of the appliance.
g) Keep the cleaning and maintenance area ventilated enough!
h) Clean all components of the appliance with compressed air after each use.
i) Clean the EPC gun assembly with a soft, dry cloth.
j) If the appliance will not be used for a prolonged time, clean the powder hoses
with compressed air.
k) Inspect the filter unit cartridge. If it is worn, replace it with a new one. Do this
by unscrewing the glass guard from the filter unit, remove and discard the
cartridge, and install a new cartridge. Clean and reinstall the glass guard.
DISPOSAL OF WASTE EQUIPMENT
At the end of its service life, this product must not be disposed of with mixed
household waste; return it to a collector/recycler of waste electrical and electronic
equipment. This is shown by the symbol placed on the product, the user manual
or the packaging. The materials used in the appliance can be reused according to
their classification identifications. By reuse, recycling or applying other forms of
use of waste appliances, you make a significant contribution to the protection of
our environment.
Local administration will provide you with the information about the nearest
disposal locations for the appliance.
TROUBLESHOOTING
Control unit error
H08
Auto mode
Auto mode
Auto mode
Auto mode
Possible cause
Dispensing air level low.
EPC gun enabled
EPC gun disabled
EPC gun online and may run if the EPC
activation icon key (E) is enabled.
EPC gun offline and may run if the EPC
activation icon key (E) is enabled.
Remedy
Correct the parameters.