Uline H-2560 Instrucciones De Montaje página 2

3. Loosely attach seats to support arms through
pre-drilled holes using 12 3½" hex lag screws,
washers and power drill with 7/16" socket bit.
(See Figure 3)
NOTE: Back edge of the seat should extend 1/2"
beyond end of support arm.
Figure 3
4. With second person, raise the arm and seat
assembly to rest on an object approximately 12"
above the mounting surface. (See Figure 4)
NOTE: It is recommended to use a five-gallon
bucket for this step.
Figure 4
PAGE 2 OF 9
ASSEMBLY CONTINUED
5. Rotate the base center support beam 90 degrees.
Align pre-drilled hole in base and secure using 3"
deck screw. Repeat for remaining bases. (See Figure 5)
Figure 5
6. Insert center support beam inside support arm. Align
pre-drilled holes, and loosely attach using 3½" hex
lag screws and washers. Repeat for remaining two
bases. (See Figure 6)
Figure 6
Anchor
Support Beam
3" Deck Screw
NOTE: Anchor blocks should rest against the
outer side of the base supports.
Block
Base Support
Washer
3½" Hex Lag Screw
Center
0622 IH-2560