Gfci Instructions; High Pressure Operation - Kärcher K1800PS Manual De Usuario

4. Pull the lever on the trigger gun to
make sure that water is flowing freely
and that all air has been purged from
the device.
NOTE: We recommend that you test
the GFCI as part of your startup
procedure each time you use the
device, see chapter GFCI
INSTRUCTIONS.
Do not use if GFCI fails test.

GFCI Instructions

1. Plug the Ground Fault Circuit Inter-
rupter (GFCI) into a working outlet.
2. Press "TEST", then press "RESET" to
assure proper connection.
1 2
NOTE: The actual appearance of the
GFCI may be different from this illustra-
tion.
Operation Instructions
ATTENTION
Pump running dry will cause
damage to the device.
10 English
If pressure does not build up in the
device after 2 minutes then switch the
device off and proceed according to
the instruction in chapter,
Troubleshooting guide.

High Pressure Operation

NOTE: Maintain a spraying distance
of at least 12 inches (30 cm) when
cleaning painted surface. Do not get
closer than 24 inches (60 cm) (0r 2
feet) when washing a vehicle.
1. Install the nozzle with the quick
connect on the end of the wand by
pulling the collar back, inserting the
soap nozzle, then pushing the collar
back. Check to make sure that
Nozzle is secure.
2. Turn on the machine by stepping
down on the foot pedal.
The motor starts when the trigger