Water Connection; Power Connection; Gfci Instructions - Kärcher HDS 3.0/20 C Ea Manual De Instrucciones

– Under no circumstances fill solvents
(petrol, aceton, diluting agent etc.)
– Avoid eye and skin contact.
– Observe safety and handling instruc-
tions by the detergent manufacturer.
Kärcher offers an individual cleaning
and care appliances program.
Your dealer will consult you gladly.
 Refill detergent.

Water connection

For connection values refer to technical
specifications.
 Attach supply hose (minimum length
24.6 ft/7.5 m, minimum diameter 3/4")
to the water supply set by means of a
hose clamp.
 Connect the supply hose to the water
connection point of the machine and at
the water supply point (for e.g. a tap).
Note: The supply hose and the hose clamp
are not included in the scope of delivery.
Suck in water from vessel
If you want to suck in water from an exter-
nal vessel, the following modification is
necessary:
Figure 6
 Remove the two screws on the burner
casing.
Figure 7
 Unscrew the back wall and remove it.
Figure 8
 Remove water connection from the fine
filter.
 Unscrew the fine filter from the pump
head.
 Remove the system care reservoir.
Figure 9
 Unscrew the top supply hose to the
swimmer container.
 Connect the top supply hose at pump
head.
 Replug the rinse line of the detergent
dosing valve to blind plugs.
 Connect suction hose (minimum diame-
ter 3/4") with filter (accessory) to the
water connection point.
– Max. suck height: 1.6 ft (0.5 m)
12
Until the pump sucked in water, you should:
 Set the pressure/quantity regulation at
the pump unit to maximum quantity.
 Close the dosing valve for the deter-
gent.
DANGER
Risk of personal injury or damage! Never
suck in water from a drinking water contain-
er. Never suck in liquids which contain sol-
vents like lacquer thinner, petrol, oil or unfil-
tered water. The sealings within the device
are not solvent resistant. The spray mist of
solvents is highly inflammable, explosive
and poisonous.
 Assembly in reverse order.
Note: Ensure that the solenoid valve cable
on the reservoir of the system care is not
pinched.

Power connection

– For connection values, see technical
data and type plate.
– The electrical connections must be
done by an electrician according to
NEC and local codes.

GFCI INSTRUCTIONS

 STEP 1: Plug the Ground Fault Circuit
Interrupter (GFCI) into a working outlet.
 STEP 2: Press ''TEST'', then press
''RESET'' to assure proper connection
to power.
Note: The actual appearance of the
GFCI may be different from this illustra-
tion.
– 5
EN