Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
- To programme "Standby – switch off", press the
"Stand-by" button. Standby Mode = no bars".
No bars
Programming is performed hour by hour. The selec-
ted hour will flash.
6. Press the "+" button to select the following time
band. Repeat the heating mode selection process
as required. Press the "-" button to return to the pre-
vious time band.
7. When all the time bands for Monday have been
programmed, press the "PROG" button to move on
to the next day, Tuesday.
Repeat all these steps to programme each day of the
week, until Sunday (7) is reached. When Sunday is
programmed, press the "PROG" button to confirm.
The programming mode screen will be displayed
containing the updated values.
Important: If you wish to modify the previously
assigned temperatures for each operating mode
then follow the steps given in section 5.5 of these
instructions.
Example programme:
- The approximate room temperature (Example
21.6 ºC).
- The current time band flashes (17:00 – 18:00).
16 | www.garsaco.com
- The mode programmed in each time band: Com-
fort Mode (sun).
- The heater element is switched on .
Note: If this symbol is not shown, the heater is not
consuming power.
Important:Pressing the "PROG" button will change
between manual and automatic modes (program-
med).
Note: After working for two or three months, the
clock will usually require adjustment.
Publicidad
Tabla de contenido
