Functioning - Olimpia splendid CALDO UP T Instruccioes Para La Instalación, Uso Y Mantenimiento

9.1 - Fan mode
While using this mode, the appliance doesn't exert any action neither
on temperature nor on air humidity in the room.
When pressing the ON/OFF
mode. The FAN LED on the appliance display turns on.
9.2 - Minimum power heating mode
When the appliance is switched on in fan mode, press button
imum power heating. In addition to the FAN LED, the LOW LED also switches on on
the appliance display.
9.3 - Maximum power heating mode
When the appliance is switched on in minimum power mode, press button
activate the maximum power heating. In addition to the FAN LED, the HIGH LED also
switches on on the appliance display (and the LOW LED switches off).
It is also possible to activate this mode through the START/STOP
button on the back of the appliance (pos. 12 - figure X).
Press button START/STOP again and the unit switches to STAND-
BY mode (and switching off occurs as described in the next para-
graph).
If one of the heating modes has been activated, press the ON/OFF
button to turn the appliance off, the FAN LED starts flashing
and the display starts the 30 seconds countdown after which the
appliance turns off (as well as the FAN LED).
9.4 - ECO mode (temperature setting)
Ambient temperature is shown on the display when the appliance is turned on.
When the appliance is on, pressing button
flash and the set temperature value to be shown.
Within 5 seconds, press buttons
18°C÷45°C - 1°C variations). Press the
the display goes back to show ambient temperature.
EN - 18

9 - FUNCTIONING

button, the appliance starts in this
and
button to confirm the setting or wait 5 seconds;
to activate the min-
will cause the temperature value to
to set the desired temperature (range:
24/7
to