Cleaning Procedure - SOLAC Siphon Brewer 3-in-1 Instrucciones De Uso

(Original instructions)
10. Rinse the siphon tube with cold water in
•
order to cool off, then you can remove it from
the lid.
11. Place the jar lid over the jar aligning the
•
"UNLOCK" line with the handle´s mark, turn
the lid clockwise until "POUR" line match with
the mark of the handle and pour.
¡CAUTION! PLACE THE LID OVER THE JAR
•
BEFORE SERVING
HOW TO DISASSEMBLE?
a) Mesh filter: Take out the mesh filter from the
•
jar by turning it strongly counter clockwise to
release it and lift.
b) Upper vessel: Hold the jar´s handle with one
•
of your hands, and then turn the upper ves-
sel counter clockwise from its handle with the
other hand to release and lift.
c) Take out the siphon tube from the jar by tur-
•
ning it counter clockwise to release and lift.
CAUTION! IF THE APPLIANCE HAVE BEEN
•
RECENTLY USED AND STILL HOT DON´T
USE YOUR BARE HANDS TO REMOVE
THE TUBE, PLEASE USE THE JAR´S LID
FOLLOWING THE STEP NUMBER 9 FROM
"COFFEE MODE" INSTRUCTIONS

CLEANING PROCEDURE

BEFORE USING THE APPLIANCE FOR THE
FIRST TIME
1. Wash thoroughly every single part of your
•
coffee machine with a soft sponge, water and
soap, with the exception of the heating plaque.
2. Follow the instructions in order to perform
•
one coffee cycle without putting any coffee into
the upper vessel.
CLEANING DIRECTIONS
1. Always remember to turn the appliance off
•
and unplug it from the electric power source.
Remove the heating plaque, since this particu-
lar item cannot be submerged or be washed
with water.
2. Wash the jar, siphon tube, jar and upper
•
vessel lids with a sponge, water and dish wash
light soap, please allow them to dry complete-
ly before assemble them again. DO NOT USE
ANY ABRASIVE FIBERS.
3. The upper vessel must be washed with hot
•
water and a soft sponge in order to maintain its
crystal clear appearance.
4. It is our recommendation to wash the mesh
•
filter with small brush so that you can remove
thoroughly the ground coffee residuals.
5. Clean the heating plaque with lightly wet
•
cloth.
6. All ensemble parts with the excep-tion of the
•
heating plaque are dish washer suitable.
7. Do not use any solvents, or acid factor PH
•
substances, or any abrasive product while cle-
aning your appliance.
8. Do not submerge or get the heating plaque
•
wet, or hold it directly under the water tap.
9. We recommend to clean the appliance regu-
•
larly and remove the ground coffee residuals
after every use.
10. You must wait for every washable ac-
•
ce-ssories to completely dry before ensemble
them back and use the appliance again.
DECALCIFICATION
In order for your coffee machine to continue its
•
perfect way of preparing your beverages, from
time to time you must get rid of the minerals
residuals left behind by the hardness of the wa-
ter with a specific anti-calc product suitable for
your coffee machine.
The frequency with which you will have to
•
perform this operation may vary depending
the water hardness of every location and how
much you use your coffee machine. If you use
your appliance twice a day follow this guide-
lines:
Soft water, every 6 months
•
Medium hard water, every 2 to 3 months
•
Hard water, every 6 to 8 weeks.
•
Fill your coffee machine with the anti-calc pro-
•
duct as if you were preparing coffee and once
the process ends, rinse thoroughly and repea-
tedly with water before using your appliance
again.
EN ES