Frequently Asked Questions - SOLAC Siphon Brewer 3-in-1 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

(Original instructions)

FREQUENTLY ASKED QUESTIONS

CONCERN
LIKELY CAUSE
I cannot turn
The jar is not properly placed
on my coffee
on the heating plaque.
machine.
Wrong ensemble.
Water do not
raise up from
Water level too low.
the jar to the
upper vessel.
You forgot to turn the coffee
machine on or to plug it to
the electrical. power source
There are
ground coffee
The mesh filter was not
or tea residuals
set properly
inside the jar.
Wrong grounding of the coffee.
Coffee does
not go down
from the upper
Too much ground coffee.
vessel to the
jar.
Ensemble the wrong way.
Overfill.
The coffee or tea
overflows or spills
Reheat,
from the upper
vessel.
Missing lid.
The water
Overfill.
overflows
the jar when
Siphon tube is set.
using as
boiler mode.
Missing lid.
SOLUTION
Remove the jar and place it again until it is correctly placed.
Verify that the siphon tube is set and secured inside the jar and that both
handles are correctly aligned.
Verify that the water level is above the minimum level of 21.12 oz. (0.6 l)
Verify that the heating plaque is connected and the appliance turned on
(red light button should be on)
Always make sure that the mesh filter is well set before using your
appliance either for making coffee or tea.
Do not forget to turn clockwise in order to correctly set the filter.
Verify that the coffee grounding is medium and not too fine since the filter
may be clogged.
Do not put more than the maximum amount of ground coffee which is 1.76
oz. (50 g)
Verify that the upper vessel is set properly over the jar and that both
handles are aligned.
Make sure not to fill with water over the jar's maximum level.
Do not reheat your coffee or tea since it can overflow the container.
The upper vessel lid is not properly placed.
Make sure not to fill the jar over its maximum limit of 23.67 oz. (0.7 l) for
water boiler mode.
Make sure the siphon tube is not set when using this mode.
he jar´s lid must be set and aligned along with the "BOIL" line as well as
the mark of the handle.
EN
ES

Publicidad

Tabla de contenido
loading

Tabla de contenido