Tool Installation And Operation - Paslode TetraGrip PF237C Manual De Instrucciones

TOOL INSTALLATION
Your Paslode tool comes ready for immediate
®
use and can be installed by following these steps:
1. SAFETY - All tool operators and their immediate
supervisors must become familiar with the opera-
tor safety instructions before operating the tool.
The instructions are on page 4 of this manual.
2. Included with each tool is a copy of the opera-
tion manual and schematic. Keep this publication
for future reference.
card is also included. This card must be completed
and returned to Paslode immediately to register
your ownership.
3. The tool comes equipped with a 3/8" male air fit-
ting and air hose. Using smaller air fittings or air
hose may adversely affect the performance of the
tool. For best performance, it is recommended that
the entire air system to be used with the tool be
equipped with 3/8 inch or larger air fittings and
hose.
4. Install a filter/regulator/lubricator unit, with a
gauge as close as practical to the tool, preferably
within ten feet. Refer to the Air Systems section of
this manual for air hose requirements and lengths.
In general, no other special installation is required.
5. If the operator is working at a bench or table, it
is usually best to run the air line underneath the
bench. A small tray under the benchtop can hold
the fastener supply and the tool when not in use.
6. If this tool does not work when it is first
connected, do not try to make repairs. Call your
Paslode representative immediately.
®
An ownership registration
®
TOOL OPERATION
Loading of Nails
Step No. 1-
Grasp the nailer handle firmly with
one hand and with the other hand depress the
door latch. Swing the magazine and door open.
Step No. 2-
Remove the retaining tape from the
nail coil and place the nail coil in the magazine
with the tips of the nails against the loading tray
and about 4 inches of coil unwound.
Step No. 3-
Slide the free strip of nails along
the top of the feeder body assembly and place
the first nail between the feed claw and into the
nose raceway.
Use only fasteners that meet Paslode specifications.
Use of fasteners that do not meet Paslode specifica-
tions can result in damage to the tool or cause injury to
the operator or bystanders.
5
WARNING
®
®