Manuales relacionados para Paslode CF325Li
Resumen de contenidos para Paslode CF325Li
- Página 1 Model CF325Li Part No. 902600 It is the customerʼs responsibility to have all operators and service personnel read and understand this manual. 2014 902613-10 7/14...
-
Página 2: Introduction And Warranty
Service Center listing that was provided with your tool. Paslode's sole liability hereunder will be to replace any part or accessory ONE-YEAR LIMITED WARRANTY which proves to be defective within the specific time period. Any replacement... -
Página 3: Tabla De Contenido
Contents Introduction and Warranty ............2 An Overview of the Paslode Cordless Framing Nailer ....4 Safety Instructions..............5 Battery and Charging System ........... 8 Fuel Cell and Metering Valve ..........10 Preparing the Paslode Cordless Framing Nailer for Use ..13 Paslode Cordless Framing Nailer Operation ......14 Fasteners and Applications ............. -
Página 4: An Overview Of The Paslode Cordless Framing Nailer
Cycle Rate: Intermittent Operation – 2 to 3 nails As with any internal combustion motor, the Paslode Cordless per second Nailer will require periodic maintenance to keep it operating at it's peak performance. The cleaning procedure booklet NOTE: Exceeding these rates could cause tool to overheat, will instruct you on the proper cleaning of your tool. -
Página 5: Safety Instructions
The following safety instructions have been included in this booklet to provide you with basic information necessary for WARNING safe operation of the Paslode Cordless Framing Nailer. DO NOT ATTEMPT TO OPERATE THIS TOOL UNTIL YOU HAVE READ AND UNDERSTAND ALL SAFETY Never expose or store the PRECAUTIONS AND MANUAL INSTRUCTIONS. - Página 6 Tip the tool nose up slightly and fasteners should working with or in the slide out of the rear of the magazine. If fasteners are vicinity of the Paslode jammed, refer to the appropriate servicing section of Cordless Framing Nailer.
- Página 7 Safety Instructions 18. KEEP YOUR HANDS CLEAR OF THE WORK AREA 13. ALWAYS MAINTAIN SECURE AND UNOBSTRUCTED SURFACE. FOOTING WHEN ON LADDERS, PLATFORMS OR OTHER HIGH LOCATIONS. WARNING WARNING A fastener may exit at an Never over-reach, since angle unexpectedly and tool recoil may cause a cause injury.
-
Página 8: Battery And Charging System
This charging system is the only one that will work with stable surface. A green light will come on to indicate Paslode Li-ion batteries. The first step in preparing a new the power is on and the charger circuit is ready. -
Página 9: Inserting Battery
Battery and Charging System Battery Indicator Light The illustration is a close-up of the side of the Paslode Cordless framer handle. On the side of the handle is a small plastic lens. This is the battery indicator light. When you insert a fully-charged battery into the tool, you will see a blinking green light. -
Página 10: Fuel Cartridge
It is not necessary to oil the tool ridge. during normal operation. When cleaning the tool, use only Paslode Cordless tool oil. Using oils not formulated for the Exposure to temperatures Paslode Cordless Tool, may cause loss of power and may above 120°F (49°C) may... - Página 11 Paslode Cordless Fuel Cell/Cartridge Disposal Guidelines Paslode the industry leader in cordless technology provides this information to assist users with the proper disposal of discarded fuel cells/cartridges. Acceptable disposal options vary depending on the type of fuel cell/cartridge users. All users must consider federal, state and local solid waste regulations to ensure that discarded fuel cells/cartridges are disposed of properly.
- Página 12 Quicklode™ Fuel Cartridge Inserting Fuel Cartridge C. Release the adaptor so it is centered on the fuel A. Inserting the fuel cartridge into the Cordless Framing cartridge. Nailer is very simple. To begin, press up at the bottom of the actuator cover and pivot outward to open.
-
Página 13: Preparing The Paslode Cordless Framing Nailer For Use
The blank cycling,which could waste fuel and damage ® use of nails that do not meet Paslode standards could cause tool components. Five (5) nails will be left in the tool damage and void your warranty. Paslode nail sizes and... -
Página 14: Paslode Cordless Framing Nailer Operation
Paslode Cordless Framing Nailer Operation PRESS WORK CONTACT ELEMENT AGAINST THE WORK SURFACE Fan motor starts, fuel is injected into combustion chamber and mixed with air by Move up to Increase the fan. Drive Depth Move Down to Reduce Probe Stop... -
Página 15: Fasteners And Applications
(Not for use in all-weather wood foundations.) Hardened Steel - For attaching wooden plates to green concrete foundations; 2X furring strips to cinder block. The Paslode Cordless Framing Nailer is not recommended for use with 3" Ring Shank nails in pressure treated lumber... -
Página 16: Servicing
DANGER sure (see page 10 for more information). Never attempt any maintenance of the Paslode Cordless Framing Nailer without first removing the fuel cartridge Clearing a Jam and battery. Maintenance should be started only after An occasional problem you may encounter is a jammed the tool is completely inoperative. -
Página 17: Air Filter
Cordless Framing Nailer Paslode Cordless Tool Accessories A variety of accessories are available for the Paslode Cordless Framing Nailer: No-Mar Work Contacting Element - Part No. 901252 Battery - Part No. 902654 Clear Safety Glasses - Part No. -
Página 18: Troubleshooting
® service. ® If tool will not operate after following the above service directions, return the tool to an authorized Paslode representative for service. For technical support call 1-800-222-6990. For factory direct Paslode replacement parts and service go to:... - Página 19 Still not working? Here are more options: • Your nailer may qualify for our Cordless 2 Year Service Promise. Visit paslode.com for more information or call us at 1-800-634-7373. • Keep your cordless nailer in top form. Visit paslode.com and watch our Cleaning and Maintenance videos.
- Página 20 An Illinois Tool Works Company 888 Forest Edge Drive Vernon Hills, Illinois 60061 www.paslode.com...