Black and Decker CS2000 Manual De Instrucciones página 22

22 • ENGLISH
and/or to deflect causing inaccurate cuts.
f Properly adjust fence angle.
f Make sure material is laying flat across base.
f Properly clamp material to avoid movement and
vibration.
MAINTENANCE
Your tool has been designed to operate over a long period
of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and
regular cleaning.
Warning! Before performing any maintenance, switch
off and unplug the tool.
f Regularly clean the ventilation slots in your tool using
a soft brush or dry cloth.
f Regularly clean the motor housing using a damp
cloth.
f Do not use any abrasive or solvent-based cleaner.
MOTOR BRUSH INSPECTION AND
REPLACEMENT (FIG. I)
Warning! Turn off and unplug the tool. Be sure the
trigger switch is in the OFF position.
Brushes should be regularly inspected for wear. To inspect
brushes, remove brush cap (23). Brushes (22) should
slide freely in brush box. If brushes are worn down to .3"
(8mm) as shown in Figure I they should be replaced.
To reinstall, push new brush back into brush box. If
replacing existing brush, maintain same orientation
as when removed. Replace the brush cap (do not
overtighten).
REPAIRS
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment should be performed by
authorized service centers or other qualified service
organizations, always using identical replacement parts.
LUBRICATION
Closed-type, grease-sealed ball bearings are used
throughout. These bearings have sufficient lubrication
packed in them at the factory to last the life of the chop
saw.
ACCESSORIES
The performance of your tool depends on the accessory
used. Black & Decker and Piranha accessories are
engineered to high quality standards and designed to
enhance the performance of your tool. By using these
accessories you will get the very best from your tool.
All manuals and user guides at all-guides.com
PROTECTING THE ENVIRONMENT
SERVICE INFORMATION
Black & Decker offers a full network of company-owned
and authorized service locations. All Black & Decker
Service Centers are staffed with trained personnel to
provide customers with efficient and reliable power tool
service. For more information about our authorized
service centers and if you need technical advice, repair,
or genuine factory replacement parts, contact the Black
& Decker location nearest you, or visit us at www.
BlackandDecker-la.com
SPECIFICATIONS
Voltage
AR
B2C
B3
B2
BR
Power
Speed
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your Black &
Decker product needs replacement, or if it is of
no further use to you, do not dispose of it with
household waste. Make this product available for
separate collection.
Separate collection of used products and
packaging allows materials to be recycled and
used again. Re-use of recycled materials helps
prevent environmental pollution and reduces the
demand for raw materials. Local regulations may
provide for separate collection of electrical
products from the household, at municipal waste
sites or by the retailer when you purchase a new
product.
CS2000
220V ~ 50Hz
220V ~ 50Hz
120V ~ 60Hz
220V ~ 60Hz
127V ~ 60Hz
2100W
3900/min (rpm)