Routine Maintenance - BM2 BIEMMEDUE ONE 650 STH Manual Del Usuario


Empty the bin;

Lower the lever locking the clip fixing the bin to the machine;

Release the clip;

Remove the bin.

Empty the bin and put back following the above operations
in reverse.

8 Routine maintenance

IMPORTANT - During routine maintenance, cleaning
and extraordinary
protection devices provided must be worn.
IMPORTANT - Failure to observe the following safety
rules may cause injury, death or damage to
equipment.
Filter shaker
knobs
Lever
Catch
Debris bin
maintenance the personal
IMPORTANT - All maintenance and cleaning must be
performed with the machine off and the key taken out.
In the case of the internal combustion engine model,
the plug cable must be detached and the motor cold
to avoid burns and fire.
Do not allow personnel not involved in maintenance
to approach the machine
8.1 Safety regulations for routine maintenance
Routine maintenance involves a series of simple operations to be
performed at regular intervals and according to the manufacturer's
instructions.
The Manufacturer has reduced the number and complexity of routine
maintenance operations to enable them to be performed by personnel
without technical expertise or complex equipment.
It involves above all:

Checking the level of fluids in the motor/engine and
replacing the motor/engine filters and battery fluids;

Adjusting and replacing belts;

Replacing parts subject to wear;

Cleaning external surfaces and internal parts;

Cleaning or replacing the suction filter.
IMPORTANT -- if oil or lubricants, must be replaced,
they must be disposed of in respect of current
legislation. Under no circumstances may they be
disposed of in the environment.
The dust contained in the refuse collection bin or
captured by the air filter may be harmful to persons
affected by chronic respiratory diseases. They should
wear suitable P.P.D.
IMPORTANT – Do not tilt the machine with the
batteries mounted: remove the batteries before tilting
the machine.
8.2 Safety regulations for cleaning the machine
All cleaning operations must be performed with the machine
stationary and turned off.
When cleaning the machine or its components, the following
precautions must be observed:
Do not clean electrical equipment with water or other fluids. To
remove dust, use a clean brush or dry cloth only. Do not clean
plastic surfaces with alcohol, detergent or solvents. Dispose of
cleaning materials in respect of current legislation. Do not
dispose of the materials used or cleaning residues in the
environment. To clean, use water or compressed air and soft
cloths. IMPORTANT - During cleaning, personnel protection
devices must be worn
IMPORTANT –- Do not use solvents to clean the
machine as there is a risk of fire due to electrostatic
discharges caused by rotation of the brushes.
Do not direct jets of water at the machine: The IP 33
degree of protection does not guarantee insulation
of the electrical components from water.
8.3 Safety regulations for repairs and
extraordinary maintenance
The Manufacturer recommends contacting authorised service centres
for all operations over and above normal routine maintenance (oil and
filter change, etc).