Hydraulic Diagram (Version / H) - battioni Pagani FAN 420 Manual De Instrucciones De Uso Y Mantenimiento

Setting the pace since 1953
- Measure the length of free stretch (t)
- In the middle of free stretch of the belt (t) apply a force(perpendicular to free stretch) nought to bend the belt 1.6 mm per 100 mm
in length of the free. For example, the decline of a free stretch of 1000 mm is 16 mm.
- Compare the force you have applied and measured through a instrument with data stated under our table. If the force is included
between "minimum force" data, it means that the belt is not enough stretched. If the force exceeds "max force" data, it means that
the belt is too stretched.
However, a new transmission can be initially tensioned to twice the value of "min strength" to allow normal adjustment of tension
during operation.
3-H) To install the rotary blades vacuum pump version ... / H, it is necessary to fi t a hydraulic motor (European unifi cation fl anging)
on the PTO shaft and to secure it, using the relevant screws, to the holder located at the front.

3.3 - HYDRAULIC DIAGRAM (VERSION / H)

The hydraulic system required for operation of the rotary blades vacuum pump version / H is schematised in the version with
uni- and bi-directional motor shown below and the technical characteristics of the hydraulic motor in Table 1. The splining of the
hydraulic engine is of the type DIN 5482 Z-23
DIAGRAM HYDRAULIC SYSTEM
WITH ONE-DIRECTIONAL MOTOR
1 Hydraulic pump
2 Over-pressure valve
3 Radiator
4 Oil fi lter
4) Then connect the intake/compression pipe of the tank car to the rotary blades vacuum pump tightening it to the adjustable elbow
using metal clamping bands in relation to the diameter of the pipe.
Length of fl exion
5 Oil tank
6 Hydraulic motor
7 Distributor
8 Drainage
Force
Section Min
Kg.
A 0.68
B 1.58
C 2.93
D 5.77
E 9.60
DIAGRAM HYDRAULIC SYSTEM
WITH TWO-DIRECTIONAL MOTOR
Max
Kg.
1.02
2.38
4.75
8.61
14.30
page 31