Storing And Recalling Broadcast Frequencies; Introduction Of Advanced Operations; Storing The Strongest Broadcast Frequencies - Pioneer DEH-P4900IB Manual De Instrucciones

Section
02 Operating this unit
4 Stereo (5) indicator
Shows when the selected frequency is being
broadcast in stereo.
5 Frequency indicator
1 Press SOURCE to select the tuner.
2 Press BAND to select a band.
Press BAND until the desired band is dis
played, FM1, FM2 for FM or MW/LW.
3 To perform manual tuning, briefly press
c or d.
4 To perform seek tuning, press and hold
c or d for about one second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancel seek tuning by briefly pressing
c or d.
# If you press and hold c or d you can skip sta
tions. Seek tuning starts as soon as you release
the button.
Note
Listening MW radio while connecting iPod to this
unit may generate noise. In this case, disconnect
iPod from this unit and noise is disappeared.
Storing and recalling broadcast
frequencies
If you press any of the preset tuning buttons 1
to 6 you can easily store up to six broadcast
frequencies for later recall with the touch of a
button.
% When you find a frequency that you
want to store in memory, press one of pre-
set tuning buttons 1 to 6 and hold until the
preset number stops flashing.
The number you have pressed will flash in the
preset number indicator and then remain lit.
The selected radio station frequency has been
stored in memory.
10
En
The next time you press the same preset tun
ing button the radio station frequency is re
called from memory.
# Up to 12 FM stations, six for each of the two
FM bands, and six MW/LW stations can be stored
in memory.
# You can also use a and b to recall radio sta
tion frequencies assigned to preset tuning but
tons 1 to 6.
Introduction of advanced
operations
% Press FUNCTION repeatedly to switch
between the following functions:
BSM (best stations memory) REGIONAL (re
gional) LOCAL (local seek tuning) TA (traf
fic announcement standby) AF (alternative
frequencies search)
# If MW/LW band is selected, you can only se
lect BSM or LOCAL.
# To return to the frequency display, press
BAND.
# If you do not operate functions within about
30 seconds, the display is automatically returned
to the ordinary display.
Storing the strongest broadcast
frequencies
BSM (best stations memory) lets you automa
tically store the six strongest broadcast fre
quencies under preset tuning buttons 1 to 6.
Once stored you can tune in to those frequen
cies with the touch of button.
! Storing broadcast frequencies with BSM
may replace broadcast frequencies you
have saved using buttons 1 to 6.
1 Press FUNCTION to select BSM.
2 Press a to turn BSM on.
Six strongest broadcast frequencies will be
stored in the order of their signal strength.
# To cancel the storage process, press b.