Adjusting Loudness; Using Subwoofer Output - Pioneer DEH-P4900IB Manual De Instrucciones

Section
02 Operating this unit
Fine-adjusting equalizer curve
You can adjust the center frequency and the Q
factor (curve characteristics) of each currently
selected curve band (EQ-LOW/EQ-MID/
EQ-HIGH).
Level (dB)
Center frequency
1 Press AUDIO and hold until frequency
and the Q factor (e.g., F-80 Q-1W) appears
in the display.
2 Press AUDIO to select the band for ad-
justment from among low, mid and high.
3 Press c or d to select the desired fre-
quency.
Low: 40 80 100 160 (Hz)
Mid: 200 500 1k 2k (Hz)
High: 3k 8k 10k 12k (Hz)
4 Press a or b to select the desired Q fac-
tor.
2W 1W 1N 2N
Note
If you make adjustments, CUSTOM curve is up
dated.

Adjusting loudness

Loudness compensates for deficiencies in the
low and high sound ranges at low volume.
1 Press AUDIO to select LOUDNESS.
2 Press a to turn loudness on.
Loudness level (e.g., LOUDNESS MID) ap
pears in the display.
# To turn loudness off, press b.
3 Press c or d to select a desired level.
LOW (low) MID (mid) HIGH (high)
20
En
Q 2W
Q 2N
Frequency (Hz)

Using subwoofer output

This unit is equipped with a subwoofer output
which can be turned on or off.
1 Press SW to select SUBWOOFER.
# You can also select the subwoofer setting
menu by pressing AUDIO on the unit.
2 Press a to turn subwoofer output on.
SUBWOOFER NOR appears in the display.
Subwoofer output is now on.
# If the subwoofer output phase has been set to
the reverse, SUBWOOFER REV will be displayed.
# To turn subwoofer output off, press b.
3 Press c or d to select the phase of sub-
woofer output.
Press c to select reverse phase and REV ap
pears in the display. Press d to select normal
phase and NOR appears in the display.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad
just the cut off frequency and the output level
of the subwoofer.
1 Press SW to select SUBWOOFER.
# You can also select the subwoofer setting
menu by pressing AUDIO on the unit.
# When the subwoofer output is on, you can se
lect SUBWOOFER (subwoofer setting).
2 Press c or d to select cut-off frequency.
50 63 80 100 125 (Hz)
Only frequencies lower than those in the se
lected range are outputted from the subwoo
fer.
3 Press a or b to adjust the output level
of the subwoofer.
+6 to –24 is displayed as the level is increased
or decreased.