TFA 35.1166.54 Instrucciones De Uso página 18

TFA_No. 35.1166_Anleitung
Wireless weather station
• Please note: When the batteries are changed, the contact
between the transmitter and the receiver must be restored – so
always insert new batteries into both devices or start the manual
search for the transmitter.
9. Additional outdoor transmitters (optional)
• When having more than one external transmitter, select a differ-
ent channel for each one with the 1 2 3 switch inside the trans-
mitter's battery compartment. Insert two new AA 1.5 V batter-
ies, polarity as illustrated. Start the base station operation or the
manual search for the outdoor transmitter:
– Choose the respective channel by pressing the CHANNEL
button.
– Press and hold the CHANNEL button for three seconds. The
last registered transmitter (channel) will be cancelled and the
transmitter search begins.
– Press the TX button in the corresponding transmitter's batte-
ry compartment. The transmission of the outdoor data will
take place immediately.
• The outdoor values and the channel number will be shown on
the base station display. If you have installed more than one
outdoor transmitter, press the CHANNEL button on the base sta-
tion to change between the channels 1 to 3.
• You can also choose an alternating channel display. Press the
CHANNEL button. After the last registered channel (1 to 3) a cir-
cle symbol will appear. To deactivate the function press the
CHANNEL button again.
• After a successful installation close the outdoor transmitter's
battery compartment carefully.
10. Troubleshooting
Problem Solution
➜ Ensure the batteries' polarities are
No indication on the
base station/transmitter
➜ Change the batteries
➜ No transmitter installed
No transmitter
➜ Check the outdoor transmitter's
reception
Display "---"
for channel 1/2/3
➜ Restart the transmitter and the base
04.07.2022 15:45 Uhr
correct
batteries (only use batteries/recharge-
able batteries with 1.5V voltage!)
station according to the manual
– 34 –
Seite 18
Wireless weather station
➜ Start the outdoor transmitter manual
search
➜ Choose another place for the outdoor
transmitter and/or the base station
➜ Reduce the distance between the
outdoor transmitter and the base
station
➜ Check if there is any source of inter-
ference
➜ Press and hold the –/MIN button for
No DCF reception
three seconds and start the initiali-
sation manually
➜ Wait for an attempt reception during
the night
➜ Choose another place for your device
➜ Set the clock manually
➜ Check if there is any source of inter-
ference
➜ Restart the instrument according to
the manual
➜ Change the batteries
Incorrect indication
If your device fails to work despite these measures, please contact
the retailer where you purchased the product from for advice.
11. Waste disposal
This product and its packaging have been manufactured using high-
grade materials and components which can be recycled and reused.
This reduces waste and protects the environment. Dispose of the
packaging in an environmentally friendly manner using the collec-
tion systems that have been set up.
Disposal of the electrical device
Remove non-permanently installed batteries and
rechargeable batteries from the device and dispose of
them separately.
This product is labelled in accordance with the EU
Waste Electrical and Electronic Equipment Directive
(WEEE).
This product must not be disposed of in ordinary
household waste.
– 35 –