Assembling The Unit - Stihl HL 91 K Manual De Instrucciones

Assembling the Unit

Mounting the Hand Guard
If a cap is fitted on the end of the drive
tube:
Pull the protective cap off the end of
N
the drive tube and keep it in a safe
place.
3
2
4
5
Push the hand guard (1) over the
N
drive tube (2) as far as stop with its
convex side facing the control
handle (3).
Fit washer (4) on the screw (5).
N
Insert the screw (5) with washer (4)
N
and tighten it down firmly.
HL 91 K
Mounting the Gearbox
Loosen the clamp screws (10).
N
Push the gearbox (11) onto the
N
drive tube (5), turn the gearbox (11)
1
back and forth as necessary.
11
10
10
5
12
11
Once the end of the drive tube is
inserted beyond the slot in the
clamp (12):
Push the gearbox (11) fully home as
N
far as stop.
Tighten down the clamp screws
N
moderately.
Line up the gearbox (11) with the
N
powerhead.
Tighten down the clamp screws
N
firmly.
English
13