Infiniton CL-73H Manual De Instrucciones página 39

XI. Functions
The display panel is illustrated as following:
When the refrigerator system is connected to power supply for the first time, all icons on the display panel gets illuminated
for 2s, and the system runs in the freezer mode at -18℃ by default. When all the doors are close, the display gets
extinguished automatically if no key operation within 3 minutes. When the display is off, it will light up if any door is opened
or any key is pressed.
The following key operations are valid only when the keys are unlocked and gets illuminated on the display. (Refer to 1.6
for unlocking the keys)
1. Functions
1.1 Switchover between fridge/freezer mode
Press and hold the Temp. key for 3s, then switchover between the fridge mode and the freezer mode can be realized.
1.2 Temp. Setting
Press the '+' or '-' for the first time, with the icon of Temp. flickering, and then press the '+' or '-' key again to adjust the
temperature to desired value, finally press the OK key or wait for 5s to validate the above temperature setting.
Temperature setting ranges cycle as follows:
In the fridge mode：2℃↔3℃↔4℃↔5℃↔6℃↔7℃↔8℃；
In the freezer mode：-16℃↔ -17℃↔ -18℃↔ -19℃↔ -20℃↔ -21℃↔ -22℃↔ -23℃↔ -24℃
；
1.3 Fast Freezing
1) When the Fast Freezing function is enabled, the compartment temperature will be controlled at -32℃ automatically,
and after 26 hours of running, the Fast Freezing function gets exited. Cooling down the freezer temperature in a rapid
manner is beneficial to the prevention of food nutrition against lost and the preservation of freshness.
Under the Fast-Freezing mode, the freezer temperature is subjected to no adjustment.
The Fast-Freezing function can be enabled only in the freezer mode.
2) Enabling the Fast Freeze function
In the freezer mode, press the Function key to select Fast Freeze until the corresponding icon gets flickering, and

then press the OK/Lock key within 5s for confirmation. If the OK/Lock key is not pressed within 5s, the setting will be
invalidated.
3) Exiting the Fast Freeze function
"After a cumulative running period of 26 hours, the Fast Freeze function will exit automatically.

Under the Fast Freeze mode, press the Function key to select Fast Freeze until the corresponding icon gets

flickering, and then press the OK/Lock key for confirmation, the Fast Freeze function will get exited.