Recipe Recall; Display; Clock; Electronic Oven Control - Sears Kenmore 665.72002 Manual De Uso Y Cuidado

ELECTRONIC OVEN CONTROL
3 4 5
w
#_ mm
m --
,,,0 ,,,0
7 8 9 10
1. RECIPE RECALL
TM
(on some models)
2. Display
3. Clock
4. Timer
5. Cooktop Lockout (on some models)/
Cooktop Light (on some models)
11 12
6. Oven Light/Oven Lockout
7. Oven Selectors (SERVE WARM on
some models)
8. Serf-Clean
SENS-A-CLEAN
TM
(on some models);
LOGICLEAN
TM
(on some models)
SELECT CLEAN
TM
(on some models)
CLEAN (on some models)
13 14
9. Temperature Setting
10. Timed Cooking
11. Hour
12. Minute
13. START/ENTER
14. OFF/CANCEL
When power is first supplied to the appliance, make sure the
surface burners are in the OFF position. Everything on the display
will light up for 5 seconds. Then the time, "PF" will appear on the
display.
Any other time "PF" appears, a power failure occurred. To
remove "PF" and to reset the clock, press OFF/CANCEL.
When the oven is in use, this display shows time, temperature
and what command pads have been pressed.
When the oven is not in use, the display will show the time of day.
The START/ENTER pad begins any oven function. If not pressed
within 5 seconds after pressing a pad, "START?" will appear on
the display as a reminder. If not pressed within 5 minutes after
pressing a pad, the display will show the time of day and the
programmed function will be cancelled.
The OFF/CANCEL pad stops any oven function except for the
Clock, Timer and Cooktop or Oven Lockouts.
After pressing OFF/CANCEL, the display will show the time of
day or, if the minute timer is also being used, the time remaining.
This is a 12 hour clock and does not show a.m. or p.m.
To Set:
1. Press CLOCK.
2. Press the HOUR/MIN "up" or "down" arrow pads until the
correct time of day shows on the display.
3. Press CLOCK or START/ENTER.
Tones are audible signals, indicating the following:
One tone
• Valid pad press
• Oven is preheating, or has been preheated
• Function has been entered
Three tones
• Invalid pad press
Four tones
• End-of-cycle
• Reminder, repeating each minute after the end-of-cycle tones
Error Tones
Error tones indicate a problem with the electronic oven control.
An error code will appear in the display.
10