Publicidad
Idiomas disponibles
Idiomas disponibles
Fit the ankle joint onto the frame (See figure 9)
- Slide the joint F into the frame A
- Position the spacers Q in the frame holes
- Thighten the screws U after having coated them
with average strength adhesive ref. XC047.
Advised thightening torque value : 11 Nm
Fit the rod and the ankle joint together (See figure10)
1. Fit the rod/eyelet assembly C1 into the rear shackle of the
joint F (see figure10).
2. Refit the pin O making sure that one of the holes * is lined
up with the tapped hole for the screw N (see figure 10).
3. Tighten the screw N after having coated it with average
strength adhesive PROTEOR ref. XC047.
CAUTION :
Do not tighten the eyelet lock nut yet.
2 - Feet assembling (See figure 11)
CAUTION : Do not tighten the eyelet lock nut yet. Keep in place tool Z.
Advised thightening torque
value : 22 Nm
1D70
1D71
1A101
1A118
1A21
G2
M10x60
(H3)
Q
U
U'
F
*
1A101
G2
M10x45
(H2)
1P5099-R-09/04
Page 10/21
Fig. 9
A
1
E
Q'
Fig. 10
1
C
1
N
3
O
Fig. 11
G2
M10x30
(H1)
Publicidad
