Operating Your Sound System - Dab - Sangean DMS-37BT Manual De Instrucciones

Operating your sound system - DAB

. Fully extend the telescopic aerial. If your sound system is in standby mode, press and release
the On / Standby button to switch it on.
2. Press and release the Source button to select DAB mode. The display will show "DAB" for a
few seconds.
3. If this is the first time the sound system is used a quick scan of the DAB channels may be
carried out (depending on whether scanning was already completed in standby mode). If the
radio has been used before, the last used station will be selected.
4. When first switched on, the first station in the list of stations will be shown. Press and release
the Select button to tune to this station or press the Tuning Up or Down buttons to select an
alternative station. See selecting a station on the following page. The display will show the
station name on the upper line of the text display and broadcast information on the lower line.
5. If the station list is still empty after the scan operation or if the selected station cannot be
received your radio will display "Service not available".
6. If no signals are found it may be necessary to relocate your sound system to a position giving
better reception, and then repeat the scan using the Auto-tune facility (see the section of
"Finding New Stations").
Note that radio station name and frequency displays shown in this user guide may differ from
those that you see on your radio. Broadcasters may change radio station names that are
transmitted, and the frequencies used for DAB and FM radio stations may not be the same in all
parts of the country.
GB
0