Fm Radio; Operating Your Radio - Search Tuning Fm - Sangean DMS-37BT Manual De Instrucciones

Operating your radio - Search tuning FM

. Fully extend the telescopic aerial.
2. Press the On / Standby button to switch on your sound system.
3. Press and release the Source button until the FM band is selected.
4. Press and release the Auto-tune button to cause your radio to scan in the direction previously
scanned and stop automatically when it finds a station of sufficient strength.
5. After a few seconds the display will update. The display will show the frequency of the signal
found. If the signal is strong enough and there is RDS data present then the radio will display
the station name.
6. To find additional stations press and release the Auto-tune button as before.
7. To scan the FM band in a opposite direction press and release either the Up Tuning button (to
scan low frequency to high frequency) or the Down Tuning button (to scan high frequency to
low frequency) and then press the Auto-tune button again.
8. When the end of the waveband is reached your radio will recommence tuning from the opposite
end.
9. Adjust the Volume to the required setting.
0. To switch off your radio press the On / Standby button.
7