Preparing The Aircraft - DJI Agras T40 Guia De Inicio Rapido

1. Propellers
2. Motors
3. ESCs
4. Aircraft Front Indicators (on two front arms)
5. Frame Arms
6. Folding Detection Sensors (built-in)
7. Spray Lance
8. Sprinklers
9. Spray Tank
10. Delivery Pumps
11. FPV Camera
Using the T40
Preparing the Intelligent Flight Battery
Only use official DJI flight batteries (
flying and charge according to the corresponding manual document.

Preparing the Aircraft

Unfold the M3 and M4 arms, and fasten the two arm locks. Avoid pinching fingers.
Unfold the M1 and M2 arms, and fasten the two arm locks. Avoid pinching fingers.
Unfold the propeller blades.
●Make sure that the battery is firmly inserted into the aircraft. Only insert or remove the battery when the aircraft is powered
off.
●To remove the battery, press and hold the clamp and lift the battery up.
●Fold the M1 and M2 arms followed by the M3 and M4 arms and make sure that the arms are inserted into the storage clamps
on both sides of the aircraft. Otherwise, the arms may be damaged.
Getting Ready for Takeoff
A. Place the aircraft on open, flat ground with the rear of the aircraft facing toward you.
B. Make sure that the propellers are securely mounted, there are no foreign objects in or on the motors and propellers, the propeller blades
12. Binocular Vision System
13. Spotlights
14. Heat Sinks
15. Phased Array Omnidirectional Radar
16. Phased Array Downward Rear Radar
17. Intelligent Flight Battery
18. Landing Gear
TM
19. OCUSYNC Image Transmission Antennas
TM
20. Onboard D-RTK
21. Aircraft Status Indicators (on two rear arms)
model: BAX601-30000mAh-52.22V
Insert the Intelligent Flight Battery into the aircraft until you hear a click.
Antennas
). Check the battery level before