Use; Filling The Blender Jug; Attaching The Blender Jug To The Motor Unit; Switching On / Selecting Speed - Silvercrest SSM 550 E1 Manual Del Usuario E Información De Servicio

Use

Filling the blender jug

1. Remove the lid (2) and measuring cap (1) from the blender jug (3).
2. Add the desired ingredients to the blender jug (3).
3. Place the lid (2) back on the blender jug (3). In so doing, ensure that the pouring spout on the
blender jug (3) is also closed.
4. Place the measuring cap (1) in the opening of the lid (2) and lock the measuring cap (1) into
position. To do this, turn it in a clockwise direction.

Attaching the blender jug to the motor unit

Warning!
If the rotary switch (4) is set at one of the various power levels, the blender will turn on as
soon as you place the blender jug on the motor unit.
1. If the mains plug is connected to the wall outlet, remove it from the wall outlet.
2. Check that the blender's rotary switch (4) is in the OFF position.
3. Place the blender jug (3) on the motor unit (6) and lock it into position. To do so, rotate the blender
jug (3) slightly until it can be pressed down.
4. Connect the power cord (5) mains plug to a live wall socket.
Warning!
Make sure the power cord is not in your working area. Otherwise you could pull it
inadvertently and knock the blender over.

Switching on / selecting speed

The blender can only be switched on once the blender jug (3) is properly locked into position
and correctly seated on the motor unit.
Warning!
The lid (2) may come loose on speed level 5 when the blender jug (3) is filled to the
maximum. This can cause the contents to be catapulted out. If necessary, hold the lid (2) down
with your hand.
1. Select the desired speed using the rotary switch (4).
SilverCrest SSM 550 E1
English - 75