Jolly Mec J20 Ficha De Montaje, Uso Y Mantenimiento página 81

Ocultar thumbs Ver también para J20:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 154
Failure on electrical devices
Power failure
If the flame does not light up during the switching on or if the smokes temperature does not
reach a suitable value in the foreseen time gap, the Boiler switches off and you will read the
words "NO LIGHTIN
LIGHTIN". On the display. Press the key "On/Off" to reset the alarm. Wait until the
NO
cooling phase is completed, clean the brazier and start a new light-up.
Switching off while working
The Boiler suddenly switches off while working (for example because it has run out of pellets in the tank
or because the motor reducer for pellets loading got broken). The Boiler continues working until the
pellets left in the brazier ends. You will then read the words "n o pe ll et
switches off. Press the key "On/Off" to reset the alarm. Wait until the cooling phase is completed. Clean
the brazier and start a new light-up.
The brazier must be cleaned and installed correctly before switching on the Boiler.
There is no power supply
In the event of a power drop longer than 30 seconds, the Boiler can exhaust some smoke in the room:
this causes no risks. As soon as you have the power supply again, the Boiler will have the words "B LAC K
" on the display. After completing the cooling phase, the Boiler will start up again automatically
OU T
OU T
according to the previous settings. (only in the self-cleaning one)
Do not attempt to start the Boiler before the required time or it may get blocked.
If this occurs, switch off the switch on the back of the pellet boiler for 1 minute,
set it on again and wait 10 minutes before starting the Boiler again.
The power socket where the Boiler is connected should be fitted with "earth
connection complying with regulations in force." The Manufacturer shall not
be held responsible for damage to things or people resulting from negligent
installation.
Intervention in case of danger: in case of fire, disconnect the power supply, use
a fire extinguisher in accordance with, and if necessary, call the fire department
and then contact the Specialised Technical Assistance Centre
"on the display and the Boiler
n o pe ll et
B LAC K
31

Publicidad

Tabla de contenido
loading

Productos relacionados para Jolly Mec J20

Este manual también es adecuado para:

J25J30J35

Tabla de contenido