Troubleshooting - Gardena ProCut 800 Manual De Instrucciones

8851-20.960.02_12.11.2008:GARDENA
Replacing the filament
cassette :
S
1
P
R

7. Troubleshooting

RISK OF INJURY !
Releasing a cutting filament
that has gone into the
cassette or which has fused :
1
16
27.11.2008
All manuals and user guides at all-guides.com
RISK OF INJURY !
A
V Never use metallic cutting elements or
replacement parts and accessories not
provided by GARDENA.
Only use original GARDENA Filament Cassettes. You can
order Replacement Filament Cassettes from your GARDENA
dealer or directly from the GARDENA Customer Service.
• Filament Cassette for
Turbotrimmer ProCut 800 / 1000 :
1. Unplug the mains plug.
M 2. Grip the filament cassette holder
N
cover .
3. Remove the filament cassette
O
and untwist the spring.
4. Remove any dirt.
N
5. Pull about 10 cm of the filament
out through the slot
M Q
6. Turn the spring
the cutting filaments
1
7. Insert the cassette
cassette holder
so that the markings
the cassette are visible in the
Q
holes in the cassette holder
When doing this the cutting
R
filaments must not get trapped.
P
8. Insert the cassette holder and
the cassette until the end of
O
S
the spindle sticks out about
5 mm.
9. Screw the cassette cover
N
R
v If the markings
holes, turn the cassette
cassette holder
Risk of injury from the cutting filament !
V Always unplug the mains plug of the Turbotrimmer
before troubleshooting.
If the cutting filament has disappeared into the filament cassette
or the tap mechanism still doesn't work after pulling the cutting
1
filament it may be fused together in the filament cassette
1. Unplug the cable from the mains.
1
2. Remove the filament cassette
6. Maintenance "Replacing the filament cassette" .
O
16:26 Seite 16
Art. No. 5308
M
and unscrew the cassette
O
from the cassette holder
1
from the new cassette
P
in the cassette.
into the new filament cassette
1
into the filament cassette holder
O
into the M
M
and turn it
R
on
M
.
R
N
onto the end of the spindle
cannot be turned until they are under the
O
to and fro until it fits into the
M
properly.
O
as described in
M
O
O
and thread
M
.
R
S
.
O
.