Turn On The Appliance And Select Programme; Turn On The Appliance; Change Programme; Add Dishes During The Programme - Fagor 3LVF-423.1 Manual De Instrucciones

TURN ON THE APPLIANCE AND SE-
LECT PROGRAMME

Turn on the appliance

1. Draw out the lower and upper basket, load the dishes and push them back. It is
commended to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. Make sure that the water supply is turned on to
full pressure.
4. Open the door, press the Power button.
5. Choose a program, the response light will turn on. Then close the door, the dish-
washer will start its cycle.

Change programme

You can change the programme only if it runs for a short time. Otherwise the deter-
gent is already dissolved in water and the water could be pumped out. In this case,
refill the dispenser with detergent and start the washing program from the beginning.
To reset your dishwasher, please follow the instructions below:
1. Press the Start/Pause button to pause the washing.
2. Press Program button for more than 3 seconds - the program will cancel.
3. Press the Program button to select the desired program.
4. Press the Start/Pause button, after 10 seconds, the dishwasher will start.

Add dishes during the programme:

You can add extra dishes at any time before detergent is released. In this case, follow
the instructions below:
1. Press the Start/Pause button to pause the washing.
2. Wait 5 seconds then open the door.
3. Add the forgotten dishes.
4. Close the door.
5. Press the Start/Pause button after 10 seconds, the dishwasher will start.
WARNING!
Be careful when opening the door during the dishwashing programme as hot steam
can be released and cause scalding.
87