Replacing The Lamp; Closing The Door - Electrolux EWUS040B8B Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 93
90
www.electrolux.com
Problem
Water flows on the rear
plate of the appliance.
Water flows inside the
wine cabinet.
Water flows inside the
wine cabinet.
The temperature in the
wine cabinet is too low or
too high.
If the advice does not lead to
the desired result, call the
nearest brand-mark service.

9.2 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Authorised
Service Centre.
Possible cause
During the automatic de‐
frosting process, frost
melts on the rear plate.
The appliance drain is
clogged.
Products prevent that
water flows into the water
collector.
The temperature regula‐
tor is not set correctly.
The door is not closed
correctly.

9.3 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to the "Installation" chapter.
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
Solution
This is correct.
Clean the appliance drain
hole. Refer to the "Cleaning
the drain" section.
Make sure that products do
not touch the rear plate.
Set a higher or lower tem‐
perature.
Refer to the "Closing the
door" section.

Publicidad

Tabla de contenido
loading

Tabla de contenido