Problem
Water flows on the rear
plate of the refrigerator.
Water flows into the re-
frigerator.
The temperature in the
appliance is too low/high.
The temperature in the
appliance is too high.
Replacing the lamp Wine Cellar
1. Disconnect the mains plug from the
mains socket.
2. Remove the lamp cover by pressing it in-
wards with a tool (e.g. screwdriver) to
free the rear side hookings. At the same
time, free the middle hook and slide off
the cover in the direction of the arrows.
3. Replace the used lamp with a new lamp
of the same type and specifically de-
signed for household appliances and
having the same characteristics.
4. Install the lamp cover.
5. Connect the mains plug to the mains
socket.
6. Open the door. Make sure that the lamp
comes on.
Possible cause
During the automatic defrosting
process, frost defrosts on the
rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
The temperature regulator is not
set correctly.
The door is not closed correctly.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
This is correct.
Clean the water outlet.
Make sure that products do not
touch the rear plate.
Set a higher/lower temperature.
Refer to "Closing the door".
Store less products at the same
time.
Make sure that there is cold air cir-
culation in the appliance.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".
electrolux 21
Solution