Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

QUICK START

ASSEMBLY
Fully assemble product prior to use.
1
Assemble the two handle grip pieces around
the handle tube and press them together.
2
Ensure the tube is in place between the handle
pieces and aligned with the holes, then use a
screwdriver to secure the two screws.
3
Snap the main body to the nozzle assembly.
Then snap the handle into the main body.
4
Plug in & charge unit until the charge indicator
light goes out (charging may take up to 7
hours.)
TIP
For best performance fully charge the
product before first use.
LED
Illumination
Slow Blink = Charging
(Indicator will blink slowly when charging)
Fast Blink = Error
(15 seconds duration for error code)
OPERATION
HOW TO USE
CAUTION:
Not to be used for grooming
a pet.
Press the standby button to turn the
machine on.
1
Push button to turn unit on.
2
Push button to turn unit off.
NOTE:
If unit shuts off during use, turn
the unit off and check for obstruction of the
brushroll & clear if obstruction is found.
Then turn the unit back on .
CHARGING
NOTE:
Use only the charger supplied by
the manufacture to recharge.
1
Indicator will blink when charging. Indicator
will turn off when charging is complete.
NOTE:
THE CHARGER WILL BE WARM WHILE
CHARGING.
NOTE:
THE UNIT WILL CHARGE ONLY FOR AS
LONG AS NEEDED. IT MAY TAKE UP TO 7 HOURS FOR
FULL CHARGE.
TIP
For best performance fully charge the
product before first use.
HOW TO USE AS A HAND VAC
1
Slide release button back then remove handle
from unit.
2
Release nozzle by pressing the tab on the back
of nozzle and pull units apart.
MAINTENANCE
HOW TO EMPTY DIRT CUP AND
REMOVE FILTER
WARNING:
To reduce the risk of
personal injury, turn power switch off before
cleaning or servicing .
1
While holding the dirt cup and handle, press
dirt cup release button.
2
Remove the dirt cup to access filter.
Dirt Cup
Filter
3
Remove the filter assembly from the dirt cup.
NOTE:
Do not discard filter or filter adapter.
4
Put the filter assembly back into the dirt cup.
Put the filter back into the dirt cup, align
bottom first and rotate up until it clicks.
NOTE:
Filter is rinseable with water. Do not
use soap/detergent. Let filter air dry for 24 hours
or until completely dry.
TIP
To maintain performance, filter should be
changed every 3-6 months, or as needed.
For replacement filter F117 visit
DIRTDEVIL.COM or call us at (800) 321-1134.

Publicidad

Tabla de contenido
loading

Tabla de contenido