Abicor Binzel MFS-V2 Instructivo De Servicio página 44

14 Options
Trigger Display
APD main menu:
Drives stop!
Stop
APD main menu:
Wire feed forward
inching
vor
APD main menu:
Wire feed backward
inching
zurück
APD main menu:
Reset
Reset
APD main menu:
Gas
Gas valve on!
Ventil ein
DG= 0.0 m/min
1
Gas
Ventil aus
2
APD main menu:
ist Select function
Heizung
Current temp=23°C
4
The heating function is only possible with the optional heating control module.
APD main menu:
plus
Select function
Heizung
Current temp=23°C
5
Setpoint= 27°C
minus
Heizung
6
The heating function is only possible with the optional heating control module.
EN - 22
Description
This trigger is used to stop the drives.
Press this trigger to activate the Wire feed mode. This mode is used to feed in the
welding wire again into the cable assembly, for example following a wire fault, a
wire spool change or for setup. In the Wire feed mode, the speed is increased in
a ramp from 0.5 to 8.0 m/min. This value is pre-set and is not affected by the set
setpoint.
This trigger is used to run the drives in Creep mode backwards. This serves, for
example, for positioning the end of wire precisely above the work-piece. To prevent
the welding wire from getting entangled, the duration of the reverse mode is
limited.
This key is used to reset the control after an error.
This trigger is used to switch the gas valve (M-Drive) on or off.
Press this trigger to display the current temperature.
Press these keys to set the desired setpoint for heating.
MFS-V2