Connecting The Hand-Held Terminal; Activate Hand-Held Terminal - Abicor Binzel MFS-V2 Instructivo De Servicio

MFS-V2
14.4.1 Features
• Offset setpoint input (wire speed) 0...10V
• Drives Stop
• Inching forward (wire feed)
• Reset (Init)
• Hardware input sensing
• Wire speed sensing (only with optional wire actual value transmitter)
• Heating regulation (only with optional heating control module)
Tab. 13 Features

14.4.2 Connecting the hand-held terminal

1 Switch off E-Box at the main switch.
2 Connect hand-held terminal to the interface X48 using the 9-pin D-SUB plug.
3 Switch on E-Box.
Display
Abicor-Binzel
hand-held terminal
V1.0a 10.03.04
APD main menu:
Select function

14.4.3 Activate hand-held terminal

1 Press HT on/off trigger.
Trigger Display
APD main menu:
HT
HT activated!
ein/aus
Enter
14.4.4 Functions
Trigger Display
APD main menu:
plus
Select function
Sollwert
DG= 0.0 m/min
8
ADoffset= 5.0V
minus
Sollwert
9
The offset remains intact even after switching the E-Box on and off.
APD main menu:
Drives start!
Start
DG= 5.0 m/min
APD main menu:
Reverse on!
Rückzug
DG= 500 m/min
• Drives Start
• Reverse
• Inching backward (short wire reverse)
• Switch on/switch off gas valve
• Setting or resetting hardware outputs
• Motor current sensing of master & slave axes (average
value in A)
• Temperature +/- , temperature actual value
Description
The display shows briefly the version and date of the software
Display shows main menu
Description
Display shows hand-held terminal activated
Description
These triggers are used to write an offset to the marker for the wire speed. The wire
speed can be set to a setpoint of between 0 and 10 V.
This trigger is used to start the drives at the set setpoint, the wire speed being
displayed if the optional wire actual value encoder was installed.
Press this trigger to run the drives at the set setpoint in reverse mode. This function
is only possible in the start mode.
14 Options
EN - 21