Safety Instructions; Electrical Connection - AEG FFB74707PM Manual De Instrucciones

4 www.aeg.com
The operating water pressure (minimum and
•
maximum) must be between 0.5 (0.05) / 10 (1.0) bar
(MPa)
Follow the maximum number of 14 place settings.
•
If the supply cord is damaged, it must be replaced by
•
the manufacturer, its Authorised Service Centre or
similarly qualified persons in order to avoid a hazard.
WARNING: Knives and other utensils with sharp
•
points must be loaded in the basket with their points
down or placed in a horizontal position.
Do not leave the appliance with the open door
•
unattended to avoid stepping accidentally onto it.
Before any maintenance operation, deactivate the
•
appliance and disconnect the mains plug from the
socket.
Do not use high pressure water sprays and/or steam
•
to clean the appliance.
If the appliance has ventilation openings in the base,
•
they must not be covered e.g. by a carpet.
The appliance is to be connected to the water mains
•
using the new supplied hose-sets. Old hose sets must
not be reused.

2. SAFETY INSTRUCTIONS

2.1 Installation
WARNING!
Only a qualified person must
install this appliance.
• Remove all the packaging.
• Do not install or use a damaged
appliance.
• Follow the installation instructions
supplied with the appliance.
• Always take care when moving the
appliance as it is heavy. Always use
safety gloves and enclosed footwear.
• Do not install or use the appliance
where the temperature is less than
0 °C.
• Install the appliance in a safe and
suitable place that meets installation
requirements.

2.2 Electrical connection

WARNING!
Risk of fire and electric
shock.
• Warning: this appliance is designed to
be installed / connected to a
grounding connection in the building.
• Make sure that the parameters on the
rating plate are compatible with the
electrical ratings of the mains power
supply.
• Always use a correctly installed
shockproof socket.
• Do not use multi-plug adapters and
extension cables.
• Make sure not to cause damage to
the mains plug and to the mains
cable. Should the mains cable need to