Removing/Inserting The Battery - Milwaukee 2528-20 Manual Del Operador

FUNCTIONAL DESCRIPTION
1
15
14
13
12
11
10
9
1. Trigger handle
2. Hose
3. Carry handle
4. Power button
5. Flow rate dial
6. Fuel gauge
7. Tank latches
8. Shoulder strap anchors
SPECIFICATIONS
Cat. No. ..................................................... 2528-20
Volts.............................................................. 12 DC
Battery Type .................................................M12™
Charger Type................................................M12™
1 Gal. Tank Cat. No. ............................. 49-16-2761
2 Gal. Tank Cat. No. ............................. 49-16-2762
Flow Rate ....................................... 0.1 to 0.3 GPM
Full Weight (1 Gallon) ....................................16 lbs
Full Weight (2 Gallon) ....................................25 lbs
Recommended Ambient
Operating Temperature ....................32°F to 125°F
2
3
4
5
6
7
8
9. Wand storage pocket
10. Tank
11. Powered head
12. Fill/measuring cup
(on back)
13. Spray wand
14. Trigger
15. Trigger lock-off
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.

Removing/Inserting the Battery

To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always lock the trigger or remove
WARNING
the battery pack any time the tool
is not in use.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool. Others
may be hazardous.
Connecting the Spray Wand to
the Trigger Handle
1. Insert the spray wand into the trigger
handle until firmly seated.
2. Slide the nut onto the threaded
coupling and hand tighten securely.
3. Pull on the spray wand to be certain
it is properly secured.
4. Place the assembled trigger handle
back into the wand storage pocket.
Connecting the Nozzles
Select and screw on nozzle by job type. When using
the adjustable nozzle, adjust spray pattern as desired
by tightening/loosening the nozzle.
Filling the Tank
Remove powered head from tank
WARNING
before filling or cleaning. Follow
chemical manufacturer's instructions for mixing,
use, and handling of chemicals. Always fill the
tank with water first, before adding chemicals.
1. Remove battery pack.
2. Remove the tank from the powered head and set
on a level surface away from the powered head
to prevent exposing to harsh chemicals.
3. Unscrew and remove
the tank cap; ensure
strainer is seated in
opening. A removable
strainer prevents de-
bris from entering the
tank that can clog or
damage the pump.
4. Fill the tank. Use the
volume markings on
the side of the tank as
a guide.
5. Reinstall the tank cap.
6. Reinstall the tank.
7. Label tank contents accordingly during each use.
Only put recommended liquids in tank.
Installing the Tank
1. Remove battery pack.
2. Secure tank to the powered head with front and
back tank latches; ensuring the powered head is
firmly seated, and all seals are aligned.
4
2
1