Installation Of The Curve Device - Ingeteam NEO Manual De Instalación

Installation
2. Identify the SIM card housing on the electronic board.
3. Insert the SIM card in its housing following the steps below:
4. Close the housing again with the 6 screws.

3.3. Installation of the CURVE device

CAUTION
The CURVE device is designed to be used with the NEO or NEO Pro single-phase charger.
1. Select the circuit on which you wish to install the CURVE device.
At the meter output
PANEL
Home power
CURVE
METER
Contracted
power
Electric
vehicle
PANEL
power
CAUTION
The operation of the CURVE device is independent of the direction of the active phase current that passes
through it.
ABV2013IQM01_ - Installation manual
In the home circuit
PANEL
CURVE
Home power
METER
Contracted
power
Electric
vehicle
PANEL
power
Ingeteam
EN
ES
FR
IT
15