Connect The Charger To The Power; Optional: Curve Device Installation (Neo Single Phase); Optional: Curvex3 Device Installation (Neo Three Phase); Optional: Connection Of The Charger To Another Charger Or A Communications Element - Ingeteam NEO Manual De Instalación

Ingeteam

3.1.9. Connect the charger to the power

Connect the electrical terminals of the power cable to the corresponding points on the charger.
CAUTION
Make sure that all screws are suitably tightened for effective contact of the active elements of the conductor.
Neutral
Phase 1
Ground
• OPTIONAL: If a CURVE device is also going to be installed, connect the wiring from that device. For more
information, see
• OPTIONAL: If the charger will be connected to a three-phase energy meter, to communications equipment
(modem, router, switch, etc.) or to another charger, connect the Ethernet wiring from that device. For
more information, see
charger or a communications

3.1.10. Optional: CURVE device installation (NEO single phase)

If it is necessary to install the CURVE device, see

3.1.11. Optional: CURVEx3 device installation (NEO three phase)

If it is necessary to install the three-phase energy meter, see
3.1.12. Optional: Connection of the charger to another charger or a
communications element
In the event that you need to connect the charger to another charger or a communications element, see
"Connection of the charger to another charger or a communications
12
NEO / NEO Pro (single phase)
"Installation of the CURVE
"Installation of the CURVEx3"
element".
"Installation of the CURVE
Neutral
Phase 1
Phase 2
Phase 3
Ground
device".
and/or "Connection of the charger to another
device".
"Installation of the
element".
NEO Pro (three-phase)
CURVEx3".
ABV2013IQM01_ - Installation manual
Installation