Bellman & Symfon BE1431 Manual De Instrucciones página 77

Default signal pattern
When the telephone transmitter is activated by an incoming call or a triggered
accessory, the following happens:
1 The LED on the transmitter lights up in green to show that it is signalling the
receiver.
2 The Visit LED on the receiver lights up in yellow and it starts to sound, flash
or vibrate with a certain pace, called signal pattern. The transmitter and the
connected accessories determine the signal pattern. The default is as follows:
Transmitter Visit receiver
Source LED LED
Landline phone Green, top Yellow light
Accessory Green, bottom Green light
Changing the signal pattern
The transmitter controls the signal pattern. Open the transmitter front cover and
move the signal switches according to the tables to change it:
152
Sound Vibration Flash
Ring signal, low Medium Yes
Door chime, low Slow Yes
Transmitter Receiver signal pattern
Switch Source LED
Landline/test button Yellow light
Mobile phone sensor Yellow blinks
Other accessory Green light
Landline/test button Yellow light
Mobile phone sensor Yellow blinks
Other accessory 2 x green blinks
Landline/test button Yellow light
Mobile phone sensor Yellow blinks
Other accessory 3 x yellow blinks
Landline/test button Yellow light
Mobile phone sensor Yellow blinks
Other accessory 2 x orange blinks Baby melody
Sound Vibration Flash
1 x ring signal, low Medium Yes
2 x ring signal, high Medium Yes
1 x door chime, low Slow Yes
1 x ring signal, low Medium Yes
2 x ring signal, high Medium Yes
2 x door chime, low Slow Yes
1 x ring signal, low Medium Yes
2 x ring signal, high Medium Yes
1 x ring signal, high Medium Yes
1 x ring signal, low Medium Yes
2 x ring signal, high Medium Yes
Fast Yes
153
App