Bellman & Symfon BE1431 Manual De Instrucciones página 80

Changing the radio key
If your Visit system is activated for no reason, there is probably a nearby system that
triggers yours. In order to avoid radio interference, you need to change the radio
key on all units. The radio key switches are located under the transmitter cover.
Here is how you change the radio key:
1 Carefully open the front cover on the transmitter. Move any radio key switch to
the up (on position) to change the radio key.
2 Press and hold the test/function button on the receiver until the green and
yellow Visit LEDs blink alternately. Release the button.
3 Press both test buttons simultaneously on the transmitter within 30 s to send
the new radio key.
4 All Visit LEDs on the receiver blink 5 times to show that the radio key has been
changed. It then returns to normal mode.
Please note that all Visit units must be set to the same radio key in order to operate
as a group.
158
1
3
2
4
5
App
159