Wheelinstallation - HOMCOM INfd002 GL Instrucciones De Montaje

The assembly of the Bike Scooter consists of 3 main steps.
1. Wheel Installation 2. Handle Bar Installation. 3. Assemble andAdjust Hand Brakes
A. WHEELINSTALLATION
Warning: If the wheel not functioning properly, do not disassemble bearings by yourself
in order to avoid improper installation to result in the wheel unworkable properly. Pls
contact the seller directly if you can not sort out the problem.
a b
c
Fig.12 - 2
Please do not unscrew the two sides of nuts (c). The clearance between the bearings was adjusted at the
factory.
Install wheels with axles pushed fully into axle slots. Make sure to install tab washers (a) so that the tab is
inserted into the round hole in the frame. This washer should be on the outside of the frame, between the
frame and axle nut. (See Fig.12- 3 )
Make sure wheels are centered, tighten the axle nuts (b) firmly with a wrench .(See Fig.12- 4 )
Fig. 12 - 3 Fig. 12 - 4