Troubleshooting Guide - EINHELL TE-SG 18/10 Li Manual De Instrucciones

11. Troubleshooting guide

Fault
No sealant or adhe-
sive at the cartridge
nozzle
Too little sealant or
adhesive at the cart-
ridge nozzle
Too much sealant or
adhesive at the cart-
ridge nozzle
For EU countries only
Never place any electric power tools in your household refuse.
To comply with European Directive 2012/19/EC concerning old electric and electronic equipment and
its implementation in national laws, old electric power tools have to be separated from other waste and
disposed of in an environment-friendly fashion, e.g. by taking to a recycling depot.
Recycling alternative to the return request:
As an alternative to returning the equipment to the manufacturer, the owner of the electrical equipment
must make sure that the equipment is properly disposed of if he no longer wants to keep the equipment.
The old equipment can be returned to a suitable collection point that will dispose of the equipment in
accordance with the national recycling and waste disposal regulations. This does not apply to any ac-
cessories or aids without electrical components supplied with the old equipment.
Please note that batteries and lamps (e.g. light bulbs) must be removed from the tool before it is dispo-
sed of.
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers ac-
companying products is permitted only with the express consent of the Einhell Germany AG.
Subject to technical changes
Anl_TE_SG_18_10_Li_SPK13.indb 22
GB
Possible cause
- The cartridge is closed
- Material has hardened in the cart-
ridge nozzle and/or in the cartridge
opening
- The cartridge is damaged
- The piston rod with piston is jam-
med
- The cartridge is empty
- The opening in the cartridge nozz-
le is too small
- The feed speed is set too low
- The sealant or adhesive is solid
- The opening in the cartridge nozz-
le is too large
- The feed speed is set too high
- 22 -
Remedy
- Open the cartridge
- Remove the hardened material, use
the piercing tool if necessary
- Replace the cartridge
- Dismantle and clean the piston rod
(see section 5.5)
- Fit a new cartridge
- Cut the cartridge nozzle to size or
replace it
- Set the feed speed higher (see sec-
tion 6.2)
- Replace the cartridge
- Cut the cartridge nozzle to size or
replace it
- Set the feed speed lower (see sec-
tion 6.2)
09.03.2022 10:22:08