Operating Instructions - Skil CR5429B-00 Manual Del Propietário

OPERATING INSTRUCTIONS

WARNING
or allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater, certain
industrial chemicals, bleach or bleach-containing products, etc. can cause a short circuit.
This cordless circular saw must be used only with the battery packs and chargers listed below:
2Ah 2Ah
SKIL SKIL
BY519701 BY519702
NOTICE: Please refer to the battery pack and charger manuals for detailed operating
information.
Trigger Switch and Lock-off
Button (Fig . 11)
To turn the tool "ON", press and hold the lock-
off button with your thumb, then squeeze the
trigger switch with your finger. Release the
lock-off button and continue to squeeze the
trigger for continued operation.
To turn the tool "OFF", release the trigger
switch, which is spring loaded and will return to
the off position automatically.
Your saw should be running at full speed
BEFORE starting the cut, and turned off only
AFTER completing the cut. To increase switch
life, do not turn switch on and off while cutting.
LED Light (Fig . 12)
Your tool is equipped with an LED light,
located behind the upper guard. This provides
additional light on the saw blade and the
surface of the workpiece for operation in lower
light areas.
The LED light will automatically turn on
when the tool starts running. It will turn off
approximately 10 seconds after the trigger
switch is released.
NOTE: When the tool and/or battery pack(s)
become overloaded or too hot, the internal
sensors will turn the tool off and the LED light
will rapidly flash. Rest the tool for a while or
place the tool and battery packs separately
under air flow for cooling.
The LED light will flash more slowly to indicate that the battery pack(s) are at low-battery
capacity. Recharge the battery packs.
To reduce the risk of fire, personal injury, and product damage due to a
short circuit, never immerse your tool, battery pack, or charger in fluid
Battery Pack
2.5Ah
SKIL
BY519703
4Ah 5Ah
SKIL SKIL
BY519601 BY519603
Fig. 11
Fig. 12
LED Light
Charger
SKIL SKIL
SC535801 QC536001
SKIL SKIL
QC5359B-02 SC5358B-02
Trigger Switch
Lock-off
Button
19