Lomography LOMOGRAFLOK 4X5 Instant Back Manual página 10

Q: Film does not develop normally under very low temperature (<5 °C).
A: Use your hand to keep the film warm after it has been ejected,
be aware not to put pressure on or bend the film.
Q: Bright dots appear in the photo and they occur in the same
position in different photos.
A: Open the Back Door [ 9 ] of your LomoGraflok and check the
roller located near the Film Ejection Slot [ 7 ] to make sure it
is clean and free of dust and dirt. Gently clean the roller if
required.
Q: The photo framing is different from how it appears on the
ground glass.
A: Check if the Film Plane Calibration & Mask Attachment [ 1 3 ]
is correctly installed, make sure the correct side is facing the
ground glass.
Q: Film is jammed while ejecting.
A: Make sure your LomoGraflok is detached from the camera
while ejecting film and Film Ejection Slot [ 7 ] is not blocked.
10