Fanimation FPS7679 Serie Manual De Instrucciones página 8

How to Hang Your Ceiling Fan (Continued)
5. Hang the motor assembly as shown. (Figure 6)
6. Make sure the electrical supply wires, including the
ground wire from supply and ceiling support cable are
pulled through the center hole of ceiling plate
assembly, between the ceiling plate assembly and the
motor assembly so that electrical connections can be
made later.
7. Attach the safety cable to ceiling support cable.
Slide cable clamp onto safety cable (from fan). Place
the end of cable through the loop of ceiling support
cable. Pull as much cable through loop as possible.
Feed end of cable into clamp hole and firmly tighten
screw (Figure 7). Cut off excess safety cable.
Ceiling Plate
Assembly
Motor
Assembly
NOTE: Supply wires
omitted for clarity
Attach Safety
Cable to Ceiling
Support Cable
Motor Assembly
NOTE: Supply wires
omitted for clarity
Ceiling Support
Cable Clamp
W/Screw
8
Figure 6
Figure 7
HARDWARE USED:
x 1