Important Safety Instructions For Battery Cartridge - Makita DWD181 Manual De Instrucciones

Important Safety Instructions for Battery Cartridge

1. Before using battery cartridge, read all instructions and cautionary
markings on (1) battery charger, (2) battery, and (3) product using
battery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively shorter, stop operating
immediately. It may result in a risk of overheating, possible burns
and even an explosion.
4. If electrolyte gets into your eyes, rinse them out with clear water
and seek medical attention right away. It may result in loss of your
eyesight.
5. Do not short the battery cartridge:
(1) Do not touch the terminals with any conductive material.
(2) Avoid storing battery cartridge in a container with other metal
objects such as nails, coins, etc.
(3) Do not expose battery cartridge to water or rain.
A battery short can cause a large current flow, overheating, possible
burns and even a breakdown.
6. Do not store the tool and battery cartridge in locations where the
temperature may reach or exceed 50 °C (122 °F).
7. Do not incinerate the battery cartridge even if it is severely damaged
or is completely worn out. The battery cartridge can explode in a fire.
8. Be careful not to drop or strike battery.
9. Do not use a damaged battery.
10. The contained lithium-ion batteries are subject to the Dangerous
Goods Legislation requirements.
For commercial transports e.g. by third parties, forwarding agents, special
requirement on packaging and labeling must be observed.
For preparation of the item being shipped, consulting an expert for
hazardous material is required.
Please also observe possibly more detailed national regulations.
Tape or mask off open contacts and pack up the battery in such a manner
that it cannot move around in the packaging.
11. When disposing the battery cartridge, remove it from the tool and
dispose of it in a safe place. Follow your local regulations relating to
disposal of battery.
12. Use the batteries only with the products specified by Makita. Installing
the batteries to non-compliant products may result in a fire, excessive
heat, explosion, or leak of electrolyte.
13. If the tool is not used for a long period of time, the battery must be
removed from the tool.
SAVE THESE INSTRUCTIONS.
18