Searching For A Pillar Behind A Gypsum Board - Makita DWD181 Manual De Instrucciones

Operation

Searching for a pillar behind a gypsum board

• Scan mode:Single Detection
• Scene:Partition
1. Turn on the scanner.
If the scanner has already been switched on, press the mode button (
2. Select the scan mode of "Single
Detection" and press the apply
button ( ).
3. Select the scan mode of "Partition"
and press the apply button (
4. Align the guide laser (the sensor's right and left edge lines) with your
intended scan position, and apply the scanner to the gypsum board.
1
1. Pillar
2. Gypsum board
).
46
2
).