Brizo MultiChoice T60P Serie Instrucciones De Montaje página 8

4 Valve Trim Installation
(See following pages for Siderna® valve trim installation.)
A.
1
Slide O-ring (1) over cartridge and the bonnet nut
(2). The O-ring, which acts as a spacer to steady
the sleeve, should rest behind the bonnet nut.
Note: Depending on the location of the valve in
the wall and wall thickness, an optional extension
kit (RP81665) can provide an additional 1 3/4" of
wall thickness.
C1.
2
3
C1: Secure the escutcheon (1) to
the bracket (2) using the 2 screws
provided (3). Do not overtighten
escutcheon screws.
2
1
B.
If your model requires a spacer (1), insert it into
the sleeve (2) and push it to the front. Slide the
sleeve over the cartridge, body and O-ring.
Cylinder trim sleeve (4) does not require a
spacer. Ensure the word FRONT points out
and slide trim sleeve all the way on over the
cartridge.
C2.
6
9
C2: Install bracket (5) over the cartridge
body using the 2 screws (6) provided. Install
escutcheon (7) by placing it over the bracket
as shown and rotating it to lock the tabs (8).
Secure the escutcheon to the bracket using set
screw (9).
6
1
2
1
4
7
5
8
109507 Rev. B
8