Kohler K-97630-NY Instrucciones De Instalación página 5

2. Measure and Trim the Locker
IMPORTANT! Use a circular saw and a fine-toothed blade to trim the locker unit.
IMPORTANT! Do not cut the sides of the locker unit. Only trim the top or bottom to fit your wall length.
IMPORTANT! The locker unit must be placed with the shelf grooves angled upward. If the locker unit is placed upside
down the shelves will fall out.
Measure the vertical installation area and determine how much of the locker top and bottom you need to trim.
Mark the cut-lines on the back side of the locker unit.
NOTE: Remove any protective films on the locker unit surface before cutting.
Cut the locker unit along the marked lines.
IMPORTANT! It is critical that the locker unit is clean to create a strong adhesive bond.
Remove excess material and sand any rough edges using a sanding block.
Clean the back of the locker unit with denatured alcohol and sand the back of the locker with 120 grit sandpaper to
promote adhesion.
Kohler Co.
Wallboard Backing
5
1484883-2-A