Preparing Of The Blower Vac Prior To Use; Assembly; Intake/ Air Outlet Tube; Fitting The Debris Collection Bag - FLORABEST FLB 3000 A1 Traducción Del Manual De Instrucciones Original

GB
4. Never let a person who is not familiar
with these operating instructions use
the machine.
5. If possible, do not operate the leaf
blower/vacuum in wet conditions.
6. Only operate the leaf blower/vacuum
when you are certain that you can stop
it quickly in the event of an emergency.
7. Never use the leaf blower/vacuum if
one or more of its safety devices is dam-
aged, incorrectly attached or missing.
8. Ensure that you have adopted a safe
and secure working position before us-
ing the machine.
9. Ensure that all screws and nuts are
firmly tightened before starting the leaf
blower/vacuum.
10. Only use the leaf blower/vacuum in
dry environments, never outside when
raining.
11. Do not use the leaf blower/vacuum if
one of its safety devices is faulty or if a
protective cover is missing.
12. Proceed with great care when cleaning.
This should only be carried out when
the leaf blower/vacuum is switched off
and disconnected from the mains in or-
der to exclude the risk of injury.
13. Check the mains cable and any exten-
sion cables used for damage and always
coil the cable up tidily and without kinks.
14. Pull the plug out of the socket:
- Before you leave the leaf blower/vacu-
um unattended for any period of time
- Before you remove potential block-
ages
- Before you check, clean or carry out
any work on the device
15. If a foreign body or other waste has ac-
cidentally entered the leaf blower/vac-
uum then stop the device immediately
and only use it again once it has been
checked and you are sure that the com-
plete leaf blower/vacuum is in a safe
operational condition.
65
16. If the leaf blower/vacuum makes unu-
sual noises or starts to vibrate STOP the
device immediately, pull the plug out
of the socket and search for the cause.
Excessive vibration can damage the leaf
blower/vacuum and injure the operator.
Preparing of the blower vac
prior to use
Warning!
The Vac-Blower must not be used or
switched on until it has been fully as-
sembled.

Assembly

Intake/ Air outlet tube

• Press the button (2.1) and slide the air
duct (2.2).
The air duct can be adjusted based on
i
user height, adjust the height up to
300 mm maximum, 30 mm is a height.

Fitting the debris collection bag

(Pic.4 and 5)
Before fitting the debris collection bag
ensure that the Vacuum/Blow selec-
tor lever operates smoothly and that
it is not obstructed by debris from the
previous use.
• turn the support (4.1) frame into the cor-
rect position of housing and make sure
the support (4.2) lock in holding fixture
(4.3).
When users dismantle the collection
bag:
• press the interlock (4.2) to release, if
the support has been released, the user
must carry the bag's weight alone.
Attention: switch off the vacuum until
at the handle and pull the plug firstly.
(Pic.2 and 3)