Precautions For Use; Stopping The Shear; Optional Anti-Cutting Function Of The Curtain Wire; Additional Information - CAMPAGNOLA SL23 Manual De Uso Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
5.1.1

Precautions for use

Never cut branches with diameter over 23 mm. Do not cut metal, stone or any other material that is not a plant. If the
blades become worn or damaged, replace them.
Keep the shear clean using a clean, dry cloth.
Do not use solvent-based degreasers or abrasives to remove dirt from the shear.
Follow the instructions for correct use of the shear. In the event of damage, do not use the shear, battery or battery
charger.
Do not use the shear if it does not work properly.
Be sure to remove the battery before any adjustment or replacement of accessories or before storing it after work is
completed. This measure reduces residual risks due to unintentional activation of the tool.
Make sure the blades are closed when the shear is not in use.
The shear must be used in accordance with the instructions and methods of use set out in this manual, taking into
account the environment and the type of work to be carried out. It is recommended that pruning shears should not be
used in the case of poor skills or specifications other than those indicated, as it is very dangerous.
After each use, remove residues from the blades and apply the manufacturer's recommended lubricant LUBE SPRAY
GREASE. This ensures that the blades are kept in good condition, reduces wear and tear and extends the life of the
shear and
blades.
5.2

Stopping the shear

The shear must be turned off at the end of the work session, therefore:
close the blades.
switch off the ON-OFF button (5).
remove the battery.
take care when storing the shear in its packaging.
5.2.1

Optional anti-cutting function of the curtain wire

The shear is equipped with an optional function (which is always disabled on delivery) to prevent accidental cutting of the
curtain wire.
Definition of "curtain wire": The term "curtain wire" refers to the wire or wires supporting the vegetation and/or shoots
that are normally present in vineyards of the type:
Espalier Vineyard
Free Cordon Vineyard
Pergola vineyard/GDC
Etc.
Or in all crops, whether climbing or not, in which there are wires (both single and multi-stranded) to support, guide etc. the
"crop" in its broadest exception.

ADDITIONAL INFORMATION

The optional function is always disabled in the tool's delivery configuration.
DANGER
The optional anti-cutting function of the curtain wire is NOT a safety function aimed at protecting people, but is
intended solely and exclusively, where possible, to limit any damage to the wire or wires supporting vegetation
and/or shoots, etc.
Function On/Off:
To insert this optional anti-cutting function of the curtain wire, proceed as follows:
The shear must be switched off.
Press and hold the power button for at least 10 sec. until the third "beep" is heard in sequence.
The optional function is now up and running.
To deactivate the optional function, proceed as follows:
a) Switch off the shear
b) Press and hold the power button for at least 10 sec. until the third "beep" is heard in sequence.
c) Switch the shear off again and put it back in the container provided.
The optional function is now deactivated and inoperative.
!
CAUTION
The optional "curtain wire cut prevention" function must always be deactivated before storing the tool, or in all
cases where it is not used.
Page 28
Use and maintenance manual – Instructions
Original instructions Rev. : 00 Date 01/07/2022

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sl32

Tabla de contenido